Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: UCamp 18 (power tongue jack conversion mod)

  Dalehelman

  July 2018
  👍
  2

• Re: The 2018 rally begins...

  Dalehelman

  July 2018
  @jkjenn Mak sure you stop by and say hi?
  1

• Re: The 2018 rally begins...

  Dalehelman

  July 2018
  @dragonsdofly Where did you get that great looking shelter?
  3

• Re: Adding a pneumatic jockey wheel

  Dalehelman

  July 2018
  It’s been attempted many times. So far know one has found one small enough. It needs to be about 6” outside diameter. You can find a 6” wheel but the tire diameter is about 8-9”. I went this route. W…
  1

• Re: Replaced stabilizers with leveling jacks

  Dalehelman

  July 2018
  It’s not that the stabilizers can’t support the weight. It’s the way the stabilizers are designed that is the problem. As the stabilizers move they come down in an arc. Once they contact the ground t…
  4

Previous Next