Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Finally T@B Parks at Home

  Dalehelman

  May 2021
  You bet. Check out the license plate frame.
  2

• Re: Finally T@B Parks at Home

  Dalehelman

  May 2021
  This is why we bought our T@B in the first place. It’s been everything I hoped it would be.
  4

• Re: 100% waterless coolant for my Alde no water no corrosion non toxic life time never needs changing

  Dalehelman

  May 2021
  The question was ask. Do I need a tight seal at the end of the vacuum wand. The answer is no, but to create the most suction the tighter the seal the better. It also will speed up the evacuation proc…
  1

• Re: Can the jack handle be moved to opposite side?

  Dalehelman

  May 2021
  I vote do it.
  2

• Re: 100% waterless coolant for my Alde no water no corrosion non toxic life time never needs changing

  Dalehelman

  May 2021
  I filled Alde with the Evans NPG yesterday. Took 7 qts. Run the circulation pump while adding coolant. No issues with air bubbles. I did make sure the auto bleed valve was horizontal. Fired it up bro…
  2

Previous Next