Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Front window rock protection

  Dalehelman

  August 2017
  I did make a modification. Aluminum strips held on by thumb screws into plastic channel. This had worked for over 3000 miles.
  8

• Re: T@B Visor XL

  Dalehelman

  August 2017
  This is my hack for holding the door partially open. By keeping the door farther from wall it also allows better air circulation for the refrigerator vent. I use it with or without the visor.
  3

• Re: Single Black & Gray Water Drain Setup

  Dalehelman

  August 2017
  Most of the time I just leave this clear section on. So when I dump I can tell when tank is clean 
  1

• Re: Solution to blown 30 amp battery fuse

  Dalehelman

  August 2017
  It's basically a thermal switch. When it heats up it opens then closes as it cools. If it doesn't close after a minute or two then there is probably a dead short somewhere that needs to be …
  1

• Re: What do you consider to be your "Most Valuable" trailer mod?

  Dalehelman

  June 2017
  Doesn't the + and - switches to the left of clock readout adjust the brightness including turning it completely black?
  1

Previous Next