Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: T@Bazona 2017 Show and Tell

  Dalehelman

  December 2016
  If anyone is interested in this mod. I am planning to bring all the parts required for the job. It is a fairly simple project. Stop by site #40 for more information.
  4

• Re: T@Bazona 2017 Show and Tell

  Dalehelman

  December 2016
  Dale & Sandi site #40 1. Articulating table that stows against wall under TV when not in use. 2. Replumbed gray water and black water dump into a single discharge point. 3. Replace shower faucet …
  1

• Re: East Meets West, Washington Style! May 18-20, 2017

  Dalehelman

  December 2016
  Dale and Sandi booked site# 66
  2

• Another holding tank heating thread

  Dalehelman

  December 2016
  This cold weather and a couple of other threads on this topic got me motivated to consider this issue. I am looking for a somewhat passive approach. In cold weather we always travel with the Alde on.…
  4

• Re: Heating the water tank.

  Dalehelman

  December 2016
  Not quite clear on your idea. The black water tank is directly under the toilet. The gray and fresh water tanks run parallel to the frame rails and are covered by a corrugated plastic sheet. The part…
  1

Previous Next