Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Seattle to The Redwoods end of March

  Dalehelman

  March 2018
  Unless temps drop below freezing for more than a couple of hours you should have know problem. In two weeks that should be less likely. Especially on the coast. 
  3

• Re: Jack wheel

  Dalehelman

  March 2018
  I make it a habit not to use the safety pin to secure the dollie wheel. That way there is no chance I can forget to remove it which could be very ugly. After I hook to the TV I run the jack up up all…
  3

• Re: (FOLLOW UP)Roof mount digital TV antenna ( attached to AC vent)

  Dalehelman

  March 2018
  Follow up on my OP of this non directional antenna. After using this antenna for over a month I couldn’t be more pleased. Like all over the air antenna’s your distance from the transmitter is directl…
  1

• Re: Frame cracks where tongue bolts to frame

  Dalehelman

  March 2018
  @ScottG My build date is 11/2014 aprox. 12,000 before cracks appeared. I had checked around 10,000 miles no cracks. Thanks for putting the spreadsheet. 
  2

• Re: Frame cracks where tongue bolts to frame

  Dalehelman

  March 2018
  I think you hit the nail on the head when you said you were dreaming. Although anything is possible. 
  3

Previous Next