Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Clug...clug...clug... goes the sway bar

  Dalehelman

  May 2021
  If you decide to leave it on. Don’t forget you must disconnect it before backing up. Serious damage can be done to your trailer tongue. If your trailer is loaded properly. Proper tongue weight and no…
  1

• Re: Crack in Trim - How serious is this?

  Dalehelman

  May 2021
  All that trim does is cover the screw heads underneath purely for looks. It is not very expensive and easy to replace. Just squeeze it together and pull it from the track. Silicones usually look wors…
  2

• Re: Corrosion of Alde Convectors

  Dalehelman

  May 2021
  @BrianZ I had Evans in our Jeep for going on 6 years. Still like new 0 water.I use a refractometer to test for water. I will be sealing the one air vent on the Alde tank. Then attach a balloon to the…
  1

• Re: Resolved: Pump Runs Continuously

  Dalehelman

  May 2021
  The pump wasn’t working hard because it was only moving air which it doesn’t do very well. The hose still in the fill receptacle has no more effect than if you were standing only on your left foot. S…
  2

• Re: Corrosion of Alde Convectors

  Dalehelman

  May 2021
  @ScottG I don’t disagree with you. I plan on taking a different tack. I am hoping to arrest and stop further corrosion by eliminating water in the system. Water being the main agent for the developme…
  3

Previous Next