Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: The Deadly Hinge!

  Dalehelman

  May 2016
  Our 2015 Sofitel came with them from the factory. The dealer had removed them for some reason but left them in the cupboard. I reinstalled them using the same holes.
  1

• Re: How do you run your refrigerator while traveling?

  Dalehelman

  May 2016
  Our first RV with a gas frig was a1972 Comander MH that's 44 years of RVing in all kinds of campers. We have traveled thousands of miles and always travel with the gas frig on. Occasionally the …
  1

• Re: Ok funny story about sewer hose storage

  Dalehelman

  March 2016
  I used 4" poly corrugated drain pipe the end caps just snap on and off. I did have to shave a little off the tabs on the RIno connector for a snug fit.
  3

• Re: Inverter recommendation needed.

  Dalehelman

  January 2016
  If you spend time where it is hot and dry. Check out Turbokool. I had one about 5 years ago. It worked very well and I would buy another. They are not cheep about $700 but they are 12 volts well desi…
  1

• Re: Flipping window shades/screen.

  Dalehelman

  February 2016
  To get those top screws you will need tools like these plus and a 1/4" open end wench. The screws are long about 1 1/2". You can only back the screw so far with the ratchet because it hits …
  2

Previous Next