Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• On door storage

  Dalehelman

  July 2016
  2

• Entry step support hack

  Dalehelman

  June 2016
  When the step is extended there is a lot of leverage and force applied to the subfloor where it is mounted. This can be very difficult to repair. By supporting the extended step you can prevent this …
  4

• Re: Ok funny story about sewer hose storage

  Dalehelman

  March 2016
  I used 4" poly corrugated drain pipe the end caps just snap on and off. I did have to shave a little off the tabs on the RIno connector for a snug fit.
  3

• Re: Keep door open with PahaQue awnings and visors

  Dalehelman

  April 2016
  My rod was1/8" square but 1/8" round will work also. I used what I had on hand. Drill your holes the same size for a nice tight fit.
  1

• Re: Lagun Style table mount with table for under $75.00

  Dalehelman

  January 2016
  This is the best table salutation I have found. The table needs to be mounted a little off center to reach the center of the isle. This has no effect on its use. pluses no vertical pole to get in the…
  1

Previous Next