Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Successfully eliminated “P” trap under sink with Hepvo valve

  Dalehelman

  September 2020
  I tried eliminating the gray water vent. If you do the air in the tank has no where to go when the sink drains so it will bubble up through the shower. Along with any fumes in the gray tank. Not good.
  1

• Re: Starting to get scared

  Dalehelman

  September 2020
  Most people but not all who by a T@B are moving up from a tent or soft sided pop up. A Roadtrek is a fairly Sophisticated RV. T@Bs are well built with fewer problems than 95% of the trailers out ther…
  2

• Re: Checking brake and turn signal lights when you're solo

  Dalehelman

  September 2020
  Correct hazard lights turn signals and brake lights are all on the same circuit.
  2

• Re: Scary newbie unhitching mistake

  Dalehelman

  September 2020
  As a little extra insurance you can leave one or both safety chains connected until you are sure the trailer is stable. Just don’t forget to unhook before you drive away. By all means chock both whee…
  6

• Re: 2021 320 S Winter Camping with Antifreeze in Gray Tank & Cassette?

  Dalehelman

  September 2020
  100% RV antifreeze no water. Blow out fresh water as well.
  2

Previous Next