Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Keep door open with PahaQue awnings and visors

  Dalehelman

  April 2016
  Another similar solution to the same problem.
  1

• Re: Frame cracks where tongue bolts to frame

  Dalehelman

  May 2018
  @PMoloney take time to read this thread from the beginning. According to the Norcold the frame manufacturer. The remaining three mounting bolts are more than sufficient to safely carry the load. Regu…
  1

• Re: Washington State East Meets West - Second Annual Gathering - May 17-20, 2018

  Dalehelman

  May 2018
  Arrived earlier today. 
  4

• If standard Command strips are not working try these.

  Dalehelman

  May 2018
  Clean surface with an alcohol wipe before use. I have yet to have these become unstuck even in hi heat conditions. They can be removed with slow and I mean slow steady pull starting at one end. They …
  2

• Re: Pictures of some of my favorite mods

  Dalehelman

  May 2018
  The T@B is a 2015 Sofitel and comes with the gray interior. It did not come with a sink in the bath.
  1

Previous Next