Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: 2019 Washington State East Meets West-Lincoln Rock

  Dalehelman

  August 2018
  Sandi and I
  2

• Re: Pneumatic tongue jack tires (revisited again)

  Dalehelman

  August 2018
  @BrianZ When the tongue is at the lowest point it is 10 3/4” to the ground. We tow with a Jeep GC it has a lift gate that clears the tire. Turn radius is a very minor issue. I cannot quite make a 90*…
  4

• Pneumatic tongue jack tires (revisited again)

  Dalehelman

  August 2018
  While on the T@B Facebook yesterday I saw a simple way to convert the standard factory wheel with two pneumatic 10” tires from Harbor Freight. It does require enlarging the axel from 1/2” to 5/8”. Yo…
  2

• Re: Are there alternative table options?

  Dalehelman

  August 2018
  This is the solution we found that works for us. The table doubles as the bed support
  1

• Re: Attention all Spokane and Pacific NW T@D@ T@B and T@G enthusiasts monthly breakfast

  Dalehelman

  August 2018
  We are in.
  1

Previous Next