Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Attention all Spokane and Pacific NW T@D@ T@B and T@G enthusiasts monthly breakfast

  Dalehelman

  October 2018
  See you all Saturday 
  1

• Re: Grey water draining solution

  Dalehelman

  September 2018
  @dsfdogs I have a macerator pump that attaches to the 3” drain and pumps into the container for transport. I have also laid the container on its back and drained directly into it. The trick is not to…
  1

• Re: Grey water draining solution

  Dalehelman

  September 2018
  I found this at Walmart and I use it transport black and gray water to the dump station. http://www.walmart.com/ip/Reliance-Hydroller-Wheeled-Water-Container-8-Gallon/10098756
  2

• Re: Ideas/ Personal Favorites for Pacific NW and N CA - Upcoming Cross country trip

  Dalehelman

  September 2018
  It is a beautiful area, but bring a rain 🧥 coat.
  1

• Re: Fluid replacement for the Alde heater

  Dalehelman

  September 2018
  Before going to the expense and trouble of replacing the transfer fluid. I purchased these test strips to check the PH in the system. The PH level was still the same as new fluid. Our trailer is four…
  1

Previous Next