Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Unhinged Storage Lid is Now Hinged

  Dalehelman

  June 2018
  Someone on Facebook turned me on to these gas struts at Walmart.com Very good quality and a super price with free shipping. https://www.walmart.com/ip/2-pack-100N-Hydraulic-Gas-Strut-Lift-Support-Cab…
  4

• Re: Has anybody upgraded to a 8,000 btu Air conditioner

  Dalehelman

  June 2018
  This has made a big difference in the Efficiently of ours cost about $4.
  6

• Re: Towing and RPM

  Dalehelman

  June 2018
  Look in your vehicles owners. Under specifications look for maximum torque RPM. Each engine size and make will be different. This applies to both gas and diesel. Use the highest gear which allows you…
  1

• Re: Tire Jack...In Order To Hit The Road...Jack!!!!

  Dalehelman

  May 2018
  @GibW I agree totally. I have tried to convince people how safe a easy this method is for over three years. Just the fact that you are supporting the trailer at three points. Instead of one when usin…
  2

• Re: New Fresh Water Fill

  Dalehelman

  April 2017
  Did your original actually break or just snap off. It has kind of a unique design in that it will snap off and can be snapped back on. I found that out purely by accident.
  1

Previous Next