Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Corrosion of Alde Convectors

  Dalehelman

  May 2021
  I am afraid that you guys are scaring the holy crap out of the hundreds maybe thousands who are following this thread. For those of you who do not have ability to perform or even understand some of t…
  5

• Re: 2007 T@B-Can I remove trim on top of camper?

  Dalehelman

  May 2021
  I do believe the early NuCamp pieces will interchange with Dutchmen. Color matching will be a problem. You may need to repaint all the trim. I do know that the parts are quite expensive. Each section…
  1

• Re: 2007 T@B-Can I remove trim on top of camper?

  Dalehelman

  May 2021
  The plastic trim is merely trim, and is not needed for weather protection. 
  1

• Re: Corrosion of Alde Convectors

  Dalehelman

  May 2021
  Here is a picture comparing the 6 year old and unused glycol. Used on the left. The ph is the same with my test strips.
  1

• Re: Bearings service past recommended mileage.

  Dalehelman

  May 2021
  Our 2015 320 is going on 6 years. Just finished a 3000 mile trip through Calif. AZ. Nev. temps in the high 90*. I have never repacked our bearings, and do not plan to. I annually and before a long tr…
  3

Previous Next