Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: New T@B family member

  Dalehelman

  September 2017
  Please tell where your home base is. 
  1

• Re: Hinges on the back shelf of 2017 T@B

  Dalehelman

  September 2017
  I put together these support's for our doors. I recently saw this same type spring support. In a new CS. Contact Elsie at NuCamp. I like them much better than the strut type and they put a lot l…
  1

• Re: Trailer Jack Woes

  Dalehelman

  September 2017
  Does someone I know get special treatment at NuCamp? If not you should
  3

• Re: Refrigerator Exhaust Vent Gets Hot

  Dalehelman

  September 2017
  The higher the outside temp the higher the exhaust temp. We don't open the door fully because it does block air flow to the vents. Especially in the summer heat. This is how we prop the door ope…
  4

• Re: Sewer extension

  Dalehelman

  September 2017
  I leave this on all the time.
  2

Previous Next