Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: T@bazona 2021 March 12 thru 14

  Dalehelman

  August 2020
  No response from Verde Ranch as yet.
  1

• Re: Generator Safety

  Dalehelman

  August 2020
  Our Honda 2000 has a vent shut off on the gas cap that works very well to eliminate unwanted fumes. I just shut off the fuel run the carburetor dry and close the vent. That being said I did convert t…
  2

• Re: Metal latch on tab off

  Dalehelman

  August 2020
  Once you find a replacement. Slip something over the end of the square shaft like a piece of rubber hose or a hose clamp to keep from losing it again.
  2

• Re: Mobility Lift

  Dalehelman

  June 2020
  I haven’t done this, but it has been rattling around in my head. Mainly because I don’t need it yet. This jack could be mounted to the outside left of the door. It would require reinforcing on the in…
  1

• Re: Protecting T@B Windows from Scratches When Using Trailer Cover

  Dalehelman

  October 2019
  Search static cling window film. I found some at Walmart in the automotive department or here. Gila Privacy Black Static Cling Residential DIY Window Film No Glue No Adhesive 3ft x 6.5ft (36in x 78in…
  1

Next