New entrance point into junction box.

Mouseketab
Mouseketab Member Posts: 1,260
edited June 14 in Battery/Electrical & Solar

I am running a new set of wires into my junction box. (DC-DC charger line zip-tied along the 7-way). The DC-DC charger is in my truck and attaches to an Anderson connector in my bumper). I see a slot opening along the side with a rubber filler in it. (Bottom/center of the box in this picture). I see some type of connectors where other entrances are. What type of connector should I get?

And just as an aside. This stupid box is in the most gosh-awful location to work on. OUCH!!!

k6efpiwt0pgp.jpeg
Carol
MOUSE-KE-T@B
2007 Dutchmen T@B Clamshell #2741
2022 nuCamp T@B 320 CS-S
2021 F-150 502A Lariat SuperCrew, 3.5 EcoBoost 4x2
Harvest, AL
· Share on FacebookShare on Twitter Share on Google+

Comments

  • Mouseketab
    Mouseketab Member Posts: 1,260
    edited June 14

    Actually nevermind. I found an actual full box kit on Amazon, and it comes with rubber grommets with holes in it and rubber grommets without holes. I'm just going to use an exacto knife and cut a hole in the existing rubber grommet. I'll smear some silicone around where the wires go in.

    61+cjWvz8sL._AC_SL1500_.jpg
    Carol
    MOUSE-KE-T@B
    2007 Dutchmen T@B Clamshell #2741
    2022 nuCamp T@B 320 CS-S
    2021 F-150 502A Lariat SuperCrew, 3.5 EcoBoost 4x2
    Harvest, AL
    · Share on FacebookShare on Twitter Share on Google+

Categories