Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: 100% waterless coolant for my Alde no water no corrosion non toxic life time never needs changing

  Dalehelman

  May 2021
  Thank you @ScottG The Evans prep fluid is designed to capture and remove any small pockets of trapped moisture. I will probably run it through 2 or 3 times as well. After preparing my Jeep it registe…
  1

• Re: Corrosion of Alde Convectors

  Dalehelman

  May 2021
  Copied from another post of mine. We are currently traveling in AZ. I was planning to wait till I got back to WA. State to inspect our system. Having nothing special to do today I decide to check it …
  1

• Re: 100% waterless coolant for my Alde no water no corrosion non toxic life time never needs changing

  Dalehelman

  May 2021
  Please help me keep this a clean dialogue with no cheap shots. I really enjoy everyone’s honest input. Question or statement then rebuttal. We are all friends here.
  2

• Re: What should my tire psi be?

  Dalehelman

  May 2021
  Our tires are rated at 50psi max load. I found at 50psi the tires were wearing in the middle of the tread. At 35psi the wear was on the outside edges. At 45psi the wear is even across tread. So 45psi…
  1

• Re: vibration

  Dalehelman

  April 2021
  Most tires that are supplied buy trailer chassis manufacturer’s are provided by the lowest bidder. Have them checked for out of round and balance. Consider new tires from a quality manufacturer.
  2

Previous Next