Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Hitch issues

  Dalehelman

  September 2017
  These hitches do not have any adjustment. Silicone is not a sufficient lubricant. Try a spray lithium or white grease. Fore and aft ball pressure on these hitches is very critical. I have seen the af…
  1

• Re: Norcold not cooling

  Dalehelman

  April 2022
  @RollinWithShirley I think the front vents will be a problem. The one on the side is not. I would contact NuCamp and see if they can give you some guidance. The fuses should be available at most hard…
  1

• Re: Attention all Spokane and Pacific NW T@D@ T@B and T@G enthusiasts monthly breakfast

  Dalehelman

  January 2022
  Sorry in able to attend tomorrow
  1

• Re: Attention all Spokane and Pacific NW T@D@ T@B and T@G enthusiasts monthly breakfast

  Dalehelman

  December 2021
  See you there.
  2

• Doing your own biannual Alde service.

  Dalehelman

  May 2021
  I have just completed draining and refilling my Alde with new coolant. The process required no special skills or tools. Just a regular wet dry Shop Vac. Simply suck out the old coolant through the fi…
  1

Previous Next