Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: BMV712 Battery Monitor: Capacity Testing & Peukert Setting

  Dalehelman

  March 2019
  @BrianZ Thanks for taking it in the spirit I meant it.
  2

• Re: Twin Bed Configuration. Easy 5.5” wider bed extensions mod.

  Dalehelman

  July 2018
  Nice work. Clean and simple. The best solution to this idea I have seen. 
  2

• Re: Tongue or Trailer Jack too long

  Dalehelman

  March 2019
  Just just cut or have someone cut 2 or 3 inches off the bottom.
  1

• Re: Plastic Trim Cracking

  Dalehelman

  March 2019
  @Maryperry1 get a #2 square bit at any hardware store. Be careful not to over tighten screws when installing new parts. That quote was outrageous.
  2

• Finding exterior water leaks

  Dalehelman

  March 2019
  Here are a couple of techniques I have used over the years for locating exterior water leaks. First close all windows. If you have a 3 way fridge use masking tape to seal outside vents. Also seal the…
  5

Previous Next