Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Pictures of some of my favorite mods

  Dalehelman

  January 2017
  I decided to put some baskets on the wire shelf. That way I can store small items and they will not fall through. So far the total investment is about $20.
  4

• Re: Another holding tank heating thread

  Dalehelman

  January 2017
  A follow up on this mod. Outside temp. 46* no wind Alde on inside temp 65* Inclosed underbelly with 1/2" bead foam insulation temp 64* This seems to be working well with low cost. foam insulatio…
  1

• "Screw it" (screw in the ground tent stakes)

  Dalehelman

  November 2016
  I found these a few months ago at Home Depot. I have used lag screws before as tent stakes. Instead of the usual spikes or stakes, but they can be very hard to pull out. These are even better. They h…
  3

• Pictures of some of my favorite mods

  Dalehelman

  November 2016
  2

• Re: Fridge Won't Light for Nothin :-(

  Dalehelman

  October 2016
  I would replace the thermalcoupler. It is the little thing stands in the middle of the pilot flame. They have a limited life span. They control the gas flow. 
  4

Previous Next