Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

  • Re: Mod day gone bad....

    DalehelmanDalehelman
    The tire and wheel size should look something like this 205/75 14 The first two numbers are the tire size the third number is the wheel size.

  • Re: winterize

    DalehelmanDalehelman
    Depends on where in AZ. Desert no mountains yes.

  • Re: Counter is hot

    DalehelmanDalehelman
    If you look into cabinet under the sink. On the right side along the top there is a wooden panel held on with a couple of screws. I removed this panel to let more air to circulate underneath the coun…

  • Wheel bearing grease

    DalehelmanDalehelman
    I just added grease to the wheel bearings on 2015 T@B through the zerk fitting on the axel stub. There is approx. 5000 miles on it. I was suprized at how much grease was needed to bring them up to fu…

  • Re: "Underbelly Protector"

    DalehelmanDalehelman
    The problem I had with a 4' wide piece was that I would have to piece it together. It requires a piece about 6'x6'. The stuff I found was 8' wide and any length so I could have on…
Avatar