Dalehelman

I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor. Good luck 

• Activity
• Posts121
• Comments2.3K

• Re: Variable Speed (PWM) Ceiling Fan Mod == 10 Bucks

  Dalehelman

  August 2018
  @MuttonChops@BrianZ You guys are the best. Just a little over my head sometimes.
  1

• Re: Variable Speed (PWM) Ceiling Fan Mod == 10 Bucks

  Dalehelman

  August 2018
  @MuttonChops I did this mod this morning. Thanks for initiating it. After reading all the posts in this thread. I almost decided To pass on this one. All in all it was much simpler than I expected. I…
  2

• Re: Successfully eliminated “P” trap under sink with Hepvo valve

  Dalehelman

  August 2018
  I left the vent on Verna’s when I did hers as well. Happy life.
  1

• Re: Entry step mod

  Dalehelman

  August 2018
  @ericnliz I thought you would pickup on that.
  2

• Re: Entry step mod

  Dalehelman

  August 2018
  Update to the support leg for my oversized step. It difficult and time consuming to adjust the step support. I needed something easier and faster. It stays attached when retracted and my cordless dri…
  1

Next