Trying to get hot water function in a 2018 T@B CS S

moonshadow · October 2017

The hot water coming through the faucets doesn't last more than 30 seconds. What are we doing wrong?

ericnliz · October 2017

@moonshadow, I had the same problem...you'll need to adjust your mixing valve. Mine was set too low, and like you, only lasted for a few seconds of hot water. You can also set the Alde hotter for hot water using the shower display button to the #2 setting. Mine is diiferent than yours, so if someone with the same set-up could post a picture, it would be helpful..Thanks.

RollingBnB · October 2017

Image: https://us.v-cdn.net/5021717/uploads/editor/dp/nze8s7omnyyk.jpg

Sharon_is_SAM · October 2017

Moonshadow, be very careful when you do this because if you loosen the screw too much you will get a bath!

moonshadow · October 2017

Thanks, I will try it. I was afraid to loosen the screw but will now with others saying it is okay to do.

pthomas745 · October 2017

I did it a few months ago after reading the information here. Go slow on the adjusting knob and change it in little increments and then test after each adjustment. It doesn't need to move very much.

My valve on a 2018 was a little different: it sits facing up. So the instructions to "move the knob out to the side" confused me a bit until I realized the difference.

Haloo · October 2017

RollingBnB said:

This worked for me! Loosened the screw, pulled out the knob to disengage it, rotated clockwise reset the knob, and turned more counter-clockwise. Hot water! Thanks!

ericnliz · October 2017

@Haloo, Glad it worked for you! Thanks for letting us know what solved the issue.

Trying to get hot water function in a 2018 T@B CS S

Comments

Categories