BrianZ
@DanWeitzel, they were 1-inch clamps and half inch wide, from Amazon..Koehler Enterprises KE12BX 10 Piece Hose Clamp Box (Size SAE 12),Silver https://a.co/d/hxrwjlzI think this was the absolute minimum size that would work, as I found myself wishing they were a bit larger, as they were more difficult to get started, especially if you had to use only one hand. I liked the 1/2" width though - seems optimal to me. If I had to do over, I'd get the next larger size over 1-inch.
-
Re: cargo nets
I'm getting some stretchy mesh fabric to try as a replacement for the OrganizedObie nets that have lost their stretchyness. Since the stretchy cords still seem to be in good shape, I will try replaci… (View Post) -
Re: Electrical Management System (EMS) Installed
One last followup.. My write-up included a photo where I described using gaffer's tape to hold the data cable to the side of the wheel well. The tape did not stand up to 90°+ temps, so I removed &… (View Post) -
Re: Fresh Water Leak - Fixed! (Again!?)
Ok, I "took the plunge" - using my plunge cutting tool.. ..to install this 4" port hole. Discovered that by lifting the lid halfway and pulling the lid part of the hinge sideways &… (View Post) -
Re: Corrosion of Alde Convectors
Well, recent posts express some of my mixed feelings about this project, as I'm in a quandary now about just how far I should go, and whether I could do more harm than good (either to my body or our … (View Post) -
Re: 2nd Time Leak at Hot Water Mix Valve Assembly in 2020 T@B 400
Our mixing valve bleeder screw hasn't leaked since using the blue Loctite I mentioned at the end of the link @Sharon_is_SAM posted. On the other hand, just tightening lasted 3 years, and it's only be… (View Post)
