BrianZ
@DanWeitzel, they were 1-inch clamps and half inch wide, from Amazon..Koehler Enterprises KE12BX 10 Piece Hose Clamp Box (Size SAE 12),Silver https://a.co/d/hxrwjlzI think this was the absolute minimum size that would work, as I found myself wishing they were a bit larger, as they were more difficult to get started, especially if you had to use only one hand. I liked the 1/2" width though - seems optimal to me. If I had to do over, I'd get the next larger size over 1-inch.
-
Re: Am I missing a cap?
We had a similar issue on our 320's A/C air vent when a tree branch pulled ours off, breaking a part, but leaving the screw on the base. Fortunately, I had installed an outdoor temp sensor inside tha… (View Post) -
Re: Scary incident - and questions
As @Marceline suggested, a mirror or cell phone would let you check the hitch easily. (View Post) -
Re: Installing a Victron Battery Monitor
@Red_Rover, One of the links above shows my victron shunt box installation in the tub. I later added a second similar box for bus bars, to clean up all the wires going into the battery box.. https://… (View Post) -
Re: Breakers and fuses
@Red_Rover Here's what the converter circuits look like in our 2018 320S, which was built in mid-2017.. Good to see that you are taking the time to get to know how your electrical system is configure… (View Post) -
Re: Post up some shots of your T@B set-up at the camp site! #3
These shots are from our recent trip to our favorite Grayson Highlands State Park in SW Virginia. It took us about 6 hours from Chester, going I-95 south to I-85, then Rte 58 west for most of the tri… (View Post)
