BrianZ
@DanWeitzel, they were 1-inch clamps and half inch wide, from Amazon..Koehler Enterprises KE12BX 10 Piece Hose Clamp Box (Size SAE 12),Silver https://a.co/d/hxrwjlzI think this was the absolute minimum size that would work, as I found myself wishing they were a bit larger, as they were more difficult to get started, especially if you had to use only one hand. I liked the 1/2" width though - seems optimal to me. If I had to do over, I'd get the next larger size over 1-inch.
-
Re: Electrical Management System (EMS) Installed
One last followup.. My write-up included a photo where I described using gaffer's tape to hold the data cable to the side of the wheel well. The tape did not stand up to 90°+ temps, so I removed &… (View Post) -
Re: Fresh Water Leak - Fixed! (Again!?)
Ok, I "took the plunge" - using my plunge cutting tool.. ..to install this 4" port hole. Discovered that by lifting the lid halfway and pulling the lid part of the hinge sideways &… (View Post) -
Re: Corrosion of Alde Convectors
Well, recent posts express some of my mixed feelings about this project, as I'm in a quandary now about just how far I should go, and whether I could do more harm than good (either to my body or our … (View Post) -
Re: 2nd Time Leak at Hot Water Mix Valve Assembly in 2020 T@B 400
Our mixing valve bleeder screw hasn't leaked since using the blue Loctite I mentioned at the end of the link @Sharon_is_SAM posted. On the other hand, just tightening lasted 3 years, and it's only be… (View Post) -
Re: Empty glycol tank
Could be a stuck or faulty air bleeder valve at the top of the Alde, which should normally only release air from the system, but could release glycol to the ground from the drain hose. Also, the valv… (View Post)
