manyman297

@WayneW You have to imagine that the axle is dropping the entire 1/2" so the overall ride height is dropping 1/2". If the axle were stationary then you'd be correct where 1/4" would be… (View Post)

Just went out and did this after replying to your post. With a little effort I was able to push mine back with my hands. (View Post)

Thanks @bergger for the thorough explanation. I'm familiar where the bleeder valves are so it shouldn't be too much of a pain to check them for air at this point. I was hoping I could test the convec… (View Post)

@pthomas745 I too experienced low pressure but realized it was do to my pressure regulator...BUT I did clean out the mixing valve and it helped. It's a really quick and easy thing to do and probably … (View Post)

Thanks @pthomas745 I've run across that thread but the sheer page count on it intimidated me. I'll go back through it again. @johnfconway The shop vac is what confused me in these threads. @ScottG si… (View Post)