Stud sizes in 7 pin connector junction box?

Comments

• Options

  tybladesmith Member Posts: 178

  November 2022

  The nut is sized at SAE #10/32 threads. Hope this helps.
  

  Kay and Tom - SW Wisconsin - Silver T@bernacle - 2018 T@B 320S Boondock Silver/Black trim TV, 2018 Chevy Colorado, Silver/Black trim, Duramax, TowHaul, IntelliHaul
  

  0 · Share on FacebookShare on Twitter Share on Google+
• Options

  Maple_Geek Member Posts: 203

  November 2022

  tybladesmith said:

  The nut is sized at SAE #10/32 threads. Hope this helps.
  

  Thanks but what doesn't it mean in terms of ring connector size? 1/4"? 3/8"?

  2022 T@B 320S Boondock
  2021 Toyota RAV4 TRD Off Road
  Ottawa, Ontario, Canada
  Instagram: new.t@bventure

  1 · Share on FacebookShare on Twitter Share on Google+
• Options

  Horigan Member Posts: 615

  November 2022

  Below a 1/4" nut sizes switch to numbers, starting at #12 and going down from there for smaller sizes.  So the stud size is #10 with 32 threads per inch.  You'll find them in hardware stores.
  
  https://www.boltdepot.com/fastener-information/printable-tools/US-Nut-Size-Chart.pdf
  

  Rich

  2019 T@b 400
  2013 Toyota Highlander 3.5L V6

  Bellingham WA

  0 · Share on FacebookShare on Twitter Share on Google+
• Options

  Maple_Geek Member Posts: 203

  November 2022

  Thanks @Horigan. I'm not looking for a nut size. I'm looking for the size of crimp on ring connector I should be ordering. Sorry if I wasn't clear. I think 1/4" will do.
  
  
  

  2022 T@B 320S Boondock
  2021 Toyota RAV4 TRD Off Road
  Ottawa, Ontario, Canada
  Instagram: new.t@bventure

  0 · Share on FacebookShare on Twitter Share on Google+
• Options

  Denny16 Member Posts: 5,431

  November 2022 edited November 2022

  First, you need to know the wire SAE size for the cable you are going to terminate (Autobrake cable wires), which is typically 8 or 10, or a combo of the two, then you need to get a crimp on ring connector that fits a No 10 stud, typically these connectors will have a blue or yellow insulator on them )see your photo).  Here is a chart showing the choices for a no 10 stud:
  https://www.mcmaster.com/crimp-lugs/insulated-ring-terminals/for-screw-size~no-10/
  
  A one quarter inch ring would be too big.
  cheers

  2018 TaB400 Custom Boondock,  Jeep Gladiator truck, Northern California Coast.

  2 · Share on FacebookShare on Twitter Share on Google+
• Options

  tybladesmith Member Posts: 178

  November 2022

  @Maple_Geek, A ring terminal for a #10 stud would be 3/16" inside diameter - 0.190" or bigger.
  
  

  Kay and Tom - SW Wisconsin - Silver T@bernacle - 2018 T@B 320S Boondock Silver/Black trim TV, 2018 Chevy Colorado, Silver/Black trim, Duramax, TowHaul, IntelliHaul
  

  1 · Share on FacebookShare on Twitter Share on Google+