Dalehelman
I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor.
Good luck
-
On door storage
-
Entry step support hack
When the step is extended there is a lot of leverage and force applied to the subfloor where it is mounted. This can be very difficult to repair. By supporting the extended step you can prevent this … (View Post) -
Re: Ok funny story about sewer hose storage
I used 4" poly corrugated drain pipe the end caps just snap on and off. I did have to shave a little off the tabs on the RIno connector for a snug fit. (View Post) -
Re: Keep door open with PahaQue awnings and visors
My rod was1/8" square but 1/8" round will work also. I used what I had on hand. Drill your holes the same size for a nice tight fit. (View Post) -
Re: Lagun Style table mount with table for under $75.00
This is the best table salutation I have found. The table needs to be mounted a little off center to reach the center of the isle. This has no effect on its use. pluses no vertical pole to get in the… (View Post)
