Dalehelman
I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor.
Good luck
-
Re: Corrosion of Alde Convectors
If you are going to change the Century fluid every 2 years. Why is the ph level of any concern? (View Post) -
Re: Corrosion of Alde Convectors
@sha Thanks learn something new everyday. (View Post) -
Power tongue Jack cost less than a buck
If you use a cordless drill for your stabilizers check this out, and it will not drain your house battery. (View Post) -
Re: Norcold not cooling
Make sure your 120 volt breaker is on. Also the fridg is plugged into an outlet under the sink. Check to see if there is power to that outlet. Fuses are under the stove top. (View Post) -
Re: Attention all Spokane and Pacific NW T@D@ T@B and T@G enthusiasts monthly breakfast
Great conversations with old and new friends (View Post)
