Flagpole Holder for Outback Platform?

@Dalehelman has the best solution. A chrome fishing pole holder that clamps to the handles of his T@B. 

@Dalehelman, Thanks Dale, now we'll have to find somethin' else to talk about at breakfast!

@Dalehelman, thanks!

@Tabaz, here are the specs from Amazon:

“1 x marine grade 304 stainless steel rod holder with marine grade 316 clamp-on bracket 
1 x Rubber insert (fitted) 
Tube length 230mm (9") 
Inside diameter 42mm 
Outside tube diameter 52mm 
this is product branded amarine-made“

I had to drill out the plastic bottom so my antenna pole would fit through it. It is very sturdy, but I did not leave it on during travel. You do need a metric Allen wrench to adjust the clamp where it connects to the handle. 

@jkjenn, I drilled the bottom out so the pole touches the ground. Then I put ball bungies at the top and bottom of the pole holder that also go around the pole to hold it in place. It was holding for a 20 mph wind.  I didn’t risk it for the 40+ mph that were coming. 

I left the rubber insert intact, but I drilled the bottom out. By using the ball bungies, the pole was snugged up and was held tightly in place. The ground also helped hold the pole in place.

Estancio said:

Dalehelman, I purchased the exact fishing rod holder that you noted in the above discussion, but it is too small to clamp around my T@B handles. Bolts are seriously too short. What did you do to make this work, longer screws perhaps.....?

The bolts that came with mine look to be about an 1 1/2”. They could have been another 1/4” longer but they did work. An Ace hardware store will likely have longer ones.