Dalehelman
I just replaced the crank with if I remember a 1/2” bolt. Just pop off the top cover for access. I think it was a 6” bolt. I cut off the thread. Then I drilled a small hole in it to match the crank handle. If you are not good with tools. Ask a friend or neighbor.
Good luck
-
Re: Pictures of some of my favorite mods
I decided to put some baskets on the wire shelf. That way I can store small items and they will not fall through. So far the total investment is about $20. (View Post) -
Re: Another holding tank heating thread
A follow up on this mod. Outside temp. 46* no wind Alde on inside temp 65* Inclosed underbelly with 1/2" bead foam insulation temp 64* This seems to be working well with low cost. foam insulatio… (View Post) -
"Screw it" (screw in the ground tent stakes)
I found these a few months ago at Home Depot. I have used lag screws before as tent stakes. Instead of the usual spikes or stakes, but they can be very hard to pull out. These are even better. They h… (View Post) -
Pictures of some of my favorite mods
-
Re: Fridge Won't Light for Nothin :-(
I would replace the thermalcoupler. It is the little thing stands in the middle of the pilot flame. They have a limited life span. They control the gas flow. (View Post)
